The Oxford | Paladin
The magnificent Paladin Oxford cast iron radiator is an ornate radiator range faithfully recreated by Paladin Radiators from one of the original decorative cast iron radiators produced in France in the late 1800s. The stunning Oxford cast iron radiator design incorporates a sweeping scalloped top detail with delicately ornate interwoven decoration which is also depicted around the foot detail of this glorious cast iron radiator.
A substantial free-standing cast iron radiator so perfect for the larger period room, barn or warehouse conversion. A tremendously heat-efficient cast iron radiator when exceptional heat is required for larger room spaces. A 4 sectioned Oxford 765mm high radiator will give a heat output of 3,016 BTU whilst a 20 sectioned Oxford 765mm will give 15,078 BTU at 60 degrees. These substantial and ornamental 3 column cast iron radiators come in 3 heights: 765mm, 570mm and 470mm.
Custom built to sizes from 3 – 30 sections and can be custom finished in the colour of your choice or hand polished. Supplied complete with plugs, bushes and air vents with ½ inch or ¾ inch connections. Delivered custom-built and finished ready for installation.
Please read Customisation & Finishes below for information about Primer Radiators
The Paladin Oxford can be delivered fully built and tested up to 14 sections which is about 1200mm long. You may have this radiator in any length but some assembly on site will be required.
Each section is approximately 81mm wide. The lengths of the radiator stated should only be used as a guide as every radiator is bespoke and hand-built to your own specification. There will be tolerances for seal compression and milled faces so please don't use these exact measurements to fix pipes. Please call us for more information or to discuss your project.
Radiator Sizes and Output (Per Section)
| Single Section Height | 470mm | 570mm | 765mm |
| Single Section Width | 81mm | 81mm | 81mm |
| Single Section Depth | 250mm | 250mm | 250mm |
| BTU ∆T 50˚C | 325 | 392 | 531 |
| Watts ∆T 50˚C | 95 | 115 | 156 |
Other Heat Outputs
| 470mm | 570mm | 765mm | |
| BTU ∆T 60˚C | 412 | 497 | 673 |
| Watts ∆T 60˚C | 121 | 146 | 197 |
| BTU ∆T 30˚C | 176 | 213 | 288 |
| Watts ∆T 30˚C | 52 | 62 | 84 |
DELTA ∆T 30˚C Best Used for Ground & Air Source Heat Pumps
HEAT LOSS CALCULATOR & RADIATOR BUILDER
Primer Finish
A standard radiator is painted with a primer before it is assembled to your specification. If it is ordered in the standard primer finish no other finishing or re-painting is done after assembly. It is expected that the customer will re-prime and paint the radiator themselves.
Each section starts life with a coat of primer, which could be black, grey or a shade of white, but this is not a guaranteed “finish" as the radiator will not be sealed. We strongly recommend that the painting is completed by the manufacturer as they use suitable radiator paint that won't be affected by the heat.
If customers are to choose & paint their own radiators, we do advise seeking advice from a paint professional. The paint finish will not be covered by the manufacturer’s warranty.
All Paladin radiators are primed in black primer before the radiator is assembled.
You can have the radiator like this and you can paint it yourself or alternately, you can let the Paladin experts paint them in a RAL, metallic, or colour matched paint. We also offer a range of special finishes including Farrow & Ball, Little Greene, polish, lacquer, antiqued paint and highlighted paint.
For full details and prices please see our Finishes page or give us a call!
