The Sloane | Paladin
The Sloane cast iron radiator design was first produced in America in the 1880's and was later manufactured in Britain under the brand name "Ideal". The Sloane cast iron radiator design is widely known, due to its finely etched detail, as the curly eared princess. The Sloane is a one column cast iron curly eared princess radiator with a wonderfully fine etched detail along is edge crowning to its top with a curled detail. Beautifully elegant, the Sloane cast iron radiator was installed in both public and privately owned buildings during the late Victorian era. The simple handsome design of the Sloane cast iron radiator provides a contemporary look for the more modern setting as well as an authentic look for the period home.
Please read Customisation & Finishes below for information about Primer Radiators
The Sloane cast iron radiator is available in 2 height choices, 450mm and 750mm. Paladins Sloane cast iron radiators are all hand built in the UK workshop by skilled technicians to sizes from 3 - 30 sections and can be custom finished in the colour of your choice or hand polished. They are tested to BS EN 442 certification standards and covered by Paladin's 10 year guarantee. They are delivered to you complete with plugs, bushes and air vents with ½ inch connections ready for installation.
Available in the full range of finishes.
The Paladin Sloane can be delivered fully built and tested up to 16 sections which is about 1200mm long. You may have this radiator in any length but some assembly on site will be required.
Each section is approximately 77mm wide. The lengths of the radiator stated should only be used as a guide as every radiator is bespoke and hand built to your own specification. There will be tolerances for seal compression and milled faces so please don't use these exact measurements to fix pipes. Please call us for more information or to discuss your project.
Radiator Sizes and Output (Per Section)
| Single Section Height | 450mm | 750mm |
| Single Section Width | 77mm | 76.5mm |
| Single Section Depth | 147mm | 147mm |
| BTU ∆T 50˚C | 186 | 303 |
| Watts ∆T 50˚C | 54 | 89 |
Other Heat Outputs
| 450mm | 750mm | |
| BTU ∆T 60˚C | 235 | 384 |
| Watts ∆T 60˚C | 69 | 112 |
| BTU ∆T 30˚C | 101 | 165 |
| Watts ∆T 30˚C | 30 | 48 |
DELTA ∆T 30˚C Best Used for Ground & Air Source Heat Pumps
HEAT LOSS CALCULATOR & RADIATOR BUILDER
Primer Finish
A standard radiator is painted with a primer before it is assembled to your specification. If it is ordered in the standard primer finish no other finishing or re-painting is done after assembly. It is expected that the customer will re-prime and paint the radiator themselves.
Each section starts life with a coat of primer, which could be black, grey or a shade of white, but this is not a guaranteed “finish" as the radiator will not be sealed. We strongly recommend that the painting is completed by the manufacturer as they use suitable radiator paint that won't be affected by the heat. If customers are to choose & paint their own radiators, we do advise seeking advice from a paint professional. The paint finish will not be covered by the manufacturer’s warranty.
All Paladin radiators are primed in black primer before the radiator is assembled.
You can have the radiator like this and you can paint it yourself or alternately, you can let the Paladin experts paint them in a RAL, metallic, or colour matched paint. We also offer a range of special finishes including Farrow & Ball, Little Greene, polish, lacquer, antiqued paint and highlighted paint.
For full details and prices please see our Finishes page or give us a call!
